Hi, the task has change processing set to Batch optimized. With performance set to trace , the log is sendeing messages about increasing latency on target as shown in Apply Latency monitor graph. Two swap file in sorter folder. After aprox. 30 minutes everything starts to work fine again.
00004580: 2022-11-22T16:26:16 [PERFORMANCE ]T: Source latency 0.19 seconds, Target latency 545.93 seconds, Handling latency 545.74 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:26:46 [PERFORMANCE ]T: Source latency 0.79 seconds, Target latency 576.06 seconds, Handling latency 575.27 seconds (replicationtask.c:3734)
00002120: 2022-11-22T16:27:11 [SORTER ]I: Task is running (sorter.c:704)
00004580: 2022-11-22T16:27:16 [PERFORMANCE ]T: Source latency 0.31 seconds, Target latency 606.19 seconds, Handling latency 605.88 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:27:46 [PERFORMANCE ]T: Source latency 0.96 seconds, Target latency 634.44 seconds, Handling latency 633.48 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:28:16 [PERFORMANCE ]T: Source latency 0.46 seconds, Target latency 664.52 seconds, Handling latency 664.06 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:28:46 [PERFORMANCE ]T: Source latency 0.81 seconds, Target latency 694.55 seconds, Handling latency 693.73 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:29:16 [PERFORMANCE ]T: Source latency 0.31 seconds, Target latency 724.63 seconds, Handling latency 724.32 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:29:47 [PERFORMANCE ]T: Source latency 0.84 seconds, Target latency 754.44 seconds, Handling latency 753.60 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:30:17 [PERFORMANCE ]T: Source latency 0.36 seconds, Target latency 784.50 seconds, Handling latency 784.14 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:30:47 [PERFORMANCE ]T: Source latency 0.88 seconds, Target latency 814.60 seconds, Handling latency 813.73 seconds (replicationtask.c:3734)
00004580: 2022-11-22T16:31:17 [PERFORMANCE ]T: Source latency 0.48 seconds, Target latency 844.47 seconds, Handling latency 843.98 seconds (replicationtask.c:3734)
Suddenly after 40 min aprox the task applies everyhing pending, and start behaving normally. This happens every time I stop the task and then resume the task, regardless the number of pending transactions to apply.
Thank You